@layersofdylan · Layers of Dylan
Saved 2026-05-15 · Posted 2024-03-25 · Status: New
Anyone else love trying to use every gram!
I know it's only .20 cents of filament but why waste it?
The glue stick file was on thingiverse in think I did 98% infill to make room for any expansion or poor tolerances.
Each stick was 5g so if you have 30g load up 6 sticks etc.
Ive got some other ideas on how to use these things.
Hope it helps you clear your rolls!
Then take those awesome cardboard @overture3dfilament
Spools to the recycling center!
Filament dryers are by @creality3d
#3dprint #3dprinting #3dprinted #3dprinter #3dprints #pla
Content ideas (0)
No ideas generated yet. Run /instagram-sync ideate from Claude Code to create some.
Comments (14)
Is that a 3d printed Ironman suit
Buy a splicer or a printer with one built in
You minus 177g off a 201g roll? I’m confused..
What to do with these empty spool??? Any suggestions
Part two shows how it's a failure. Don't waste your time.
Genius !!
smart 👏🙌
Nice idea. I love ways to get the last bit
Great idea
I need that... a whole iron man suit, sign me up. And I definitely am gonna gram an NUC, or two, write some basic codes, and make a Jarvis system for it
Nice solution! I’m lazy and don’t weigh anymore, just count the remaining coils so I can go by length. Your glue gun method’s got me wondering how to make mini “injection molded” items
Wait this is actually so smart
Why didn’t I think of this. You sir are a genius 🙌
A had this type of Video back to back