Saved 2026-05-15 · Posted 2024-04-28 · Status: New
Did you know about these? 🤔 . I’m all about flexible PEI sheets but these are a cool alternative! #3dprinter #3dprinters #3dprintinglife #additivemanufacturing #printfarm
Comments
(15)
@foxthetodd♥ 22024-04-30
I love this build plate, holds up to all their claims. I’ve printed PLA, PETG, PET and TPU. Great success on each. Though FYI it has its own temp requirements for each, they aren’t the same as regular plates.
@acupof.joe♥ 22024-04-28
Tried this out with silk PLA and couldn’t get it to stick at all
@golden_state_natives♥ 12024-04-29
Can you make some pistol magazines for me? I only need a couple dozen or so....
@el_pancho01082024-07-26
My prints with PC still require glue stick😢, but this build plate is still great!
@maxim.vt12024-07-18
Does PP stick well to it ?
@thatguy_mckenzie2024-07-06
Have you tried big flat parts with >=50% infill? Any warping up at the corners?
@sylvesterwolfs82024-06-30
Still needed a brim tho
@steampunk_balis2024-06-25
This thing is amazing! Common problem: people don't go online and see the smooth pei/high temp plate setting is recommended by lightyear
@3dprinter_zone2024-05-15
❤️🔥
@colinkonijn2024-05-10
How do you get that texture on your prints? That’s amazing! 🤩
@beskar_armoury2024-05-08
Try it without a raft and I’ll be impressed
@purdyyyyyy2024-05-03
do they have 400x400 plates
@serg1239872024-05-03
Made my own from .2 mm sheet of g10 off of ali and removed the pei sheet and it works great for under 20 bucks with the adhesive
@practical_3d2024-04-30
What's that filament used in the video?
@playdrivecnc2024-04-29
Keen to hear how asa goes on something like this too
Content ideas (0)
No ideas generated yet. Run /instagram-sync ideate from Claude Code to create some.
Comments (15)
I love this build plate, holds up to all their claims. I’ve printed PLA, PETG, PET and TPU. Great success on each. Though FYI it has its own temp requirements for each, they aren’t the same as regular plates.
Tried this out with silk PLA and couldn’t get it to stick at all
Can you make some pistol magazines for me? I only need a couple dozen or so....
My prints with PC still require glue stick😢, but this build plate is still great!
Does PP stick well to it ?
Have you tried big flat parts with >=50% infill? Any warping up at the corners?
Still needed a brim tho
This thing is amazing! Common problem: people don't go online and see the smooth pei/high temp plate setting is recommended by lightyear
❤️🔥
How do you get that texture on your prints? That’s amazing! 🤩
Try it without a raft and I’ll be impressed
do they have 400x400 plates
Made my own from .2 mm sheet of g10 off of ali and removed the pei sheet and it works great for under 20 bucks with the adhesive
What's that filament used in the video?
Keen to hear how asa goes on something like this too