@bryanprints3d · BryanPrints3D
Saved 2026-05-15 · Posted 2024-07-15 · Status: New
Every filament and printer behaves differently together. This allows you to optimize that. Note: This did not fix my issue that I showed at the beginning of the video, but this process was still very helpful and educational #3dprinting #bambulab #flowratecalibration #a1printer
Content ideas (0)
No ideas generated yet. Run /instagram-sync ideate from Claude Code to create some.
Comments (15)
0.71...? Bro you have to do it again 🤦🏽♂️
What is it when you have it checked off right before each print next two time lapse and bed calibration there's something called Flow Dynamics checked off doesn't it do that every time you print
Bit of Oil on the nozzle helps too
informative and straightforward. great video
So you did a pressure advance and a flow rate calibration.
Lol whoever bought a 3d printer starts making videos like they know everything and newbies seeing these videos make mistakes, then hate this beautiful hobby eventually at some point.
Thanks for sharing that information.
Is this also applicable for the mini?
Definitely overshot
Will make good looking weak underextruded parts
I’ve been wanting to do this !
This is so helpful!! Thank you!!
I would verify your first layer height and z height is accurate. I've been printing for about a decade and have never had any major quality issues with the proper z height. Only once the height is verified to be accurate would i suggest touching the flow rate if you are still having issues. One major reason being that z height can have a major effect on these tests.
👏👏👏
🔥ץ
🔥ץ