← Tools
Open on Instagram ↗

Comments (15)

  • @barteckinicpon 2025-05-05

    We recently had a case of a ground fault in the installation of 10 electric chargers. A flat cable was used as the power supply line along with those connection boxes. The gasket was not sealed properly, and water started to get in. As a result, the entire installation had to be replaced with a standard cable. The downside of the flat cable is that it can only be used once.✌️

  • @antoine.lanaud 2025-04-25

    The surface of contact with that conical screw look so tiny . And with Thermal contraction and extension this doesn't look durable at all.

  • @jacko_aichecker 2025-04-13

    Redneck electric

  • @rotor_racer420 2025-03-31

    That looks like the most Jenn ass piece of shit thing that I’ve ever seen in my life besides this bullshit that somebody come up with called a in the wall splice that is no longer allowed in the electric code the same way this piece of trash won’t be in the next year if I have anything to say about it.

  • @rorifett 2025-07-28

    What's the general plan when you decide to remove or move the socket? Those permanent holes in the feed are a bit worrisome

  • @high_plains_falcon 2025-06-15

    Tighten up terminals and screws with an impactor way over the top 🔥

  • @allonlineelectrical 2025-06-12

    The shark bite of electrical 😂😂😂

  • @jonesrepresentacoeseagregados 2025-06-09

    👏🏽👏🏽👏🏽👏🏽

  • @gavbutel 2025-05-31

    What is that?

  • @danilinius 2025-05-30

    @ildar_ap прокалыватели проводов вышли на новый уровень 😂

  • @dominicristaino 2025-05-29

    I'm an electrician in the US and I'm honestly curious about this, mine explaining🤔

  • @93_jonh 2025-04-29

    We use these at our conveyor system at LAX they actually surprisingly work pretty good.

  • @pnxelectrical 2025-04-12

    Used for overhead cranes and high-level bus systems in warehousing and such

  • @zasinstalaciones 2025-04-02

    Mala conexión provoca vibraciones,que calientan los componentes,seguro que es buena idea?

  • @chrisleslie7 2025-03-27

    So what’s it fucking for

Content ideas (0)

No ideas generated yet. Run /instagram-sync ideate from Claude Code to create some.