Saved 2026-05-15 · Posted 2026-03-14 · Status: New
How I get my parts to press fit together every time
Comments
(15)
@serhat._.yuksel♥ 892026-03-14
But which filament is strong enough for this? I used PLA and it keeps breaking
@toothpasteonyourtoothbrush♥ 152026-03-14
Wouldn’t work well for blind holes though, would it?
@cedric__hebert♥ 42026-03-15
What’s the tolerance you’re using?
@polcabases♥ 22026-04-07
hey! Would it be possible to get the 3D files?
@brentpeluso♥ 22026-03-18
Hey! What is the geometry of the mating hole? Just a straight hole? I’m having a hard time imagining why it clicks
@black_bullet5.0♥ 22026-03-14
What is software you use
@gr8vilen♥ 12026-04-28
Wht software is it ?
@3d_keychains_and_more♥ 12026-03-16
This can be done in Bambu slicer
@jellyfox360♥ 12026-03-15
Thanks! This just solved a massive problem I was having. Your measurements made it work perfect
@_opsilon_♥ 12026-03-15
What do you recommend for a part that needs to snap fit but also be removed periodically
@cikaspersen♥ 12026-03-14
Software u are using?
@solacealex♥ 12026-03-14
Does it unclick easily?
@maticalles2026-05-05
This is a bad idea, pushing the little rod in place applies force to the piece in the very worst direction you can think off, over a very little surface. Even more if you leave the widest part being the top, which give even more leverage over the flexion point. It will snap if you dont print it sideways
@the_worst_train_crashes2026-04-18
I hate these they always break
@alignedfurniture2026-03-15
Great but what is the name of the software
Content ideas (0)
No ideas generated yet. Run /instagram-sync ideate from Claude Code to create some.
Comments (15)
But which filament is strong enough for this? I used PLA and it keeps breaking
Wouldn’t work well for blind holes though, would it?
What’s the tolerance you’re using?
hey! Would it be possible to get the 3D files?
Hey! What is the geometry of the mating hole? Just a straight hole? I’m having a hard time imagining why it clicks
What is software you use
Wht software is it ?
This can be done in Bambu slicer
Thanks! This just solved a massive problem I was having. Your measurements made it work perfect
What do you recommend for a part that needs to snap fit but also be removed periodically
Software u are using?
Does it unclick easily?
This is a bad idea, pushing the little rod in place applies force to the piece in the very worst direction you can think off, over a very little surface. Even more if you leave the widest part being the top, which give even more leverage over the flexion point. It will snap if you dont print it sideways
I hate these they always break
Great but what is the name of the software