Saved 2026-05-15 · Posted 2026-03-12 · Status: New
You can’t always trust your slicer. By repositioning the bridging along a shorter distance, we eliminated those sagging layers. Small adjustments, big results.
Comments
(4)
@jaacckh♥ 172026-03-12
Prusa slicer is garbage
@jesse.hamad♥ 102026-03-13
Was printing an object (bambu slicer) that had a series of 20cm long, 1/2 cm wide channels.. guess which direction it decided to bridge? By some miracle it worked out fine but holy cow it was painful to watch
@andrei_22_rey♥ 22026-04-05
Orca does this too, and bambu🤣 it s all fun and games, when it s starting that, you watch it, you go to drink some water and come back to a surprise 50/50 spaghetti or a masterpiece
@montanamountainminerals♥ 12026-04-01
Elegoo slicer does this also
Content ideas (0)
No ideas generated yet. Run /instagram-sync ideate from Claude Code to create some.
Comments (4)
Prusa slicer is garbage
Was printing an object (bambu slicer) that had a series of 20cm long, 1/2 cm wide channels.. guess which direction it decided to bridge? By some miracle it worked out fine but holy cow it was painful to watch
Orca does this too, and bambu🤣 it s all fun and games, when it s starting that, you watch it, you go to drink some water and come back to a surprise 50/50 spaghetti or a masterpiece
Elegoo slicer does this also