Comments (15)

• @apexweldingltd ♥ 140 2026-03-19

  The people I work with would drill a hole straight through that table 😡

• @lwplanthire ♥ 57 2026-03-19

  It’s cool, but I’ll stick to my Bridgeport thanks

• @cars_pens_trees ♥ 31 2026-03-19

  Would be an excellent idea to add a removable tray underneath the work surface to collect chips.

• @koidogg.industrys ♥ 8 2026-03-19

  awesome setup for a small garage. I could use that. how's the balance with the drill press off the back?

• @dta_fabrication ♥ 7 2026-03-19

  This is awesome! Thanks for inspiring another project as if I didnt have enough already.

• @gimi58 ♥ 6 2026-03-19

  Jason please stop making all these wonderful upgrades, I have a 2×3 Dragon Wagon that works nicely in my garage shop. This drill press idea would be nice. Can you come up with a drill press adapter for it? My wife won't let me buy another fixture table.

• @weekendersolutions ♥ 3 2026-03-19

  Thinks a great idea, my shop is small so I need everything to be as efficient as possible

• @hemiman348 ♥ 2 2026-03-20

  What drill press is that one?

• @thecutrate ♥ 2 2026-03-20

  Ok add this to the list of stuff I’m ordering from you… 😅

• @rcw67 ♥ 2 2026-03-20

  looks great add a chip try pan underneath 👍

• @gemeneraal ♥ 1 2026-03-22

  Shouldn't the COG of the drill be inside the four wheels mate?

• @innominelibertas ♥ 1 2026-03-21

  it does not seem rigid. once you start pushing the drill it will get out of square

• @benlongdang ♥ 1 2026-03-20

  On my drill press I added a right angle drill that is electric powered. Then just made an adaptor, it's amazing. Now moving up and down just a little is possible and you don't have to use a height that is too low and leaving that height because it still works but you have to go basically with the full travel. It makes it like a mil with powered z

• @mark_scranton ♥ 1 2026-03-19

  How much is it?

• @coda.pedro 2026-03-21

  Could you share the plans?