← 3D printing Open on Instagram ↗ Share Delete @hen3drik · Hendrik Vogelpohl Saved 2026-05-19 · Posted 2026-04-05 · Status: New DIY electroplating #3dprinted custom #jewelry. Copper plated on graphite on resin. #3dprinting model by ezzysziggy Comments (13) @mate0114 ♥ 17 2026-03-27 What conductive paint do you use? @hen3drik ♥ 8 2026-03-27 It is indistinguishable. 🙂 @canadian_dart_reviews_sorry ♥ 4 2026-03-27 Gotta find out how and if can go at home and how safe it is. Love to do this to some 3d prints I have. Hopefully safe and not too expensive to start @purpledevildice ♥ 3 2026-04-18 Always have wanted to see this broken (to see insides) @femfataletron ♥ 3 2026-04-07 You are one of my favourite YouTubers. Your videos have given me a lot of confidence in attempting electroplating at home. @nico.kho_ ♥ 2 2026-03-27 why use a servo to spin it around? preventing uneven electroplating? @thesamgerard ♥ 1 2026-05-24 Can this be performed with FDM prints or only resin? @gudieeco ♥ 1 2026-05-20 Very nice combination of 3D printing and science! 🧪 @drjulianjaramillo ♥ 1 2026-04-08 Very nice! @miscfit0121 ♥ 1 2026-04-06 Those look great! I’d love to see a stress test video… do they bend or snap under pressure? @vimal_raj___ ♥ 1 2026-04-06 Still plastic is inside, is there any way to remove that plastic? @jesper_kukla 2026-04-07 Bei mir schwimmen die Teile immer oben im Elektrolyt. Was soll ich machen? @meredith_solutions 2026-03-28 If I have parts that fit together, roughly how much does this change my tolerance? Content ideas (0) No ideas generated yet. Run /instagram-sync ideate from Claude Code to create some.
Comments (13)
What conductive paint do you use?
It is indistinguishable. 🙂
Gotta find out how and if can go at home and how safe it is. Love to do this to some 3d prints I have. Hopefully safe and not too expensive to start
Always have wanted to see this broken (to see insides)
You are one of my favourite YouTubers. Your videos have given me a lot of confidence in attempting electroplating at home.
why use a servo to spin it around? preventing uneven electroplating?
Can this be performed with FDM prints or only resin?
Very nice combination of 3D printing and science! 🧪
Very nice!
Those look great! I’d love to see a stress test video… do they bend or snap under pressure?
Still plastic is inside, is there any way to remove that plastic?
Bei mir schwimmen die Teile immer oben im Elektrolyt. Was soll ich machen?
If I have parts that fit together, roughly how much does this change my tolerance?