@ruvimkub · Ruvim KUB
Saved 2026-05-15 · Posted 2025-10-24 · Status: New
Two tools that turn crown molding work into an easy game. These are real tools that I personally use every day — and I absolutely love them.
The link to the tool is in the profile or here.The link to the tool is in the profile or here.
https://www.etsy.com/listing/1876020908/
#construction #carpentry #crownmolding #3dprinting #tools #3dkub @bambulab_official
Content ideas (0)
No ideas generated yet. Run /instagram-sync ideate from Claude Code to create some.
Comments (15)
the line follows the ceiling so you just scribed the ceiling and are now bending the trim to match the ceiling instead of snapping a line and keeping it straight...😂
I’ve been a residential carpenter for 32 years and trim work is my specialty. I understand the cool stuff. I’m with you with pneumatic nailer. I haven’t found a battery or gas powered trim gun yet that weighs as little as my pneumatic gun…. Or is as reliable fastener after fastener after fastener. Where I differ is that I’m a curmudgeon. After decades of doing it my way I’m still happy with it. I cut a little block for the reveal and make a couple of marks along the wall. Then I take my nail set and just tack it 1/8 inch above the reveal to support the crown. I’m sure you know how to do that as well…… I’m just stuck in the past. You’ve posted good work and I don’t have any problem with it… I’m just used to doing it my way.
Anybody know where I can find that xcool suction tool?? That would be a game changer!!
Awesome Ruvim 👏
That is slick! The scriber is cool but the suction tool for holding it? Need it!!!
🔥
Genius
If the gap is on the top roll down the wall and if the gap is on the bottom roll up the wall. But looks pretty good!! Nice tools for the job
Guessing that's timber?
А где клей?
Круто, прям топчик в цьому ділі 🔥
🔥
@ruvimkub who makes the vacuum tool for the crown?
Where can the suction holder be purchased
Where can I find the STL or where to buy that crown bracket?